Series 115 - Solenoid Control Valves

The OCV Series 115 Solenoid Control Valve is designed to provide on/off or open/close control of fluids in response to an electrical signal. The valve consists of the basic OCV model 65 with solenoid-operated pilot. With the appropriate solenoid, the valve may be normally closed (energize to open) or normally open (de-energize to open).

• Model 115-1 Solenoid Shut-Off Valve
• Model 115-1NY Solenoid Shut-Off Valve
• Model 115-26 Solenoid Shut-Off & Check Valve
• Model 115-3 Solenoid Control Valve
• Model 115-4 Solenoid Shut-Off Valve High-Capacity
• Model 115AV Programmable Solenoid Shut-Off Valve
• Model 115-1FP Anti-Flood System

Valve Features

• Operates automatically off line pressure.
• Heavy-duty, nylon-reinforced diaphragm.
• Rectangular-shaped, soft seat seal provides drip-tight Class VI closure.
• Diaphragm assembly Guided top and bottom.
• Throttling seat retainer for flow and pressure stability.
• Easily maintained without removal from the line.
• Replaceable seat ring.
• Alignment pins assure proper reassembly after maintenance.
• Valves are factory tested.
• Valves are serial numbered and registered to facilitate replacement parts and factory support.

ZONE CONTROL

Used in irrigation and industrial processes, each flow line can be activated independently of others.

LEVEL CONTROL

Valve, activated by level sensor, fills storage tank.

Valve Operation

Components

1. Basic Valve
2. 2-way solenoid
3. 3-way solenoid
4. 3-way auxiliary pilot
5. Ejector
6. Needle valve speed control
7. Y-strainer
8. Isolation ball valve

MODEL 115-1 THREE-WAY SOLENOID

Operated by a 3-way solenoid. The main valve diaphragm chamber may be exhausted to atmosphere, allowing for full open operation at any flow rate. Standard with needle valve opening/closing speed control adjustment. Size ranges 1 ¼” – 4″, consult factory on application of larger sizes.

MODEL 115-2 TWO-WAY SOLENOID

Operated by a 2-way solenoid and ejector. The main valve diaphragm is exhausted to valve outlet port. Valve position is determined by flow rate demand (differential pressure). Standard with needle valve opening/closing speed control adjustment. Size ranges 1 ¼” – 6″, consult factory on application of larger sizes.

MODEL 115-3 POSITIONED VALVE

Operated by two 2-way solenoids, the valve maybe positioned from full closed to full open or locked in any intermediate position. Equipped with both opening and closing speed adjustment. The valve can be configured to open, close, or hold position in the event of electrical power failure. The Model 115-3 is the basis for the OCV Series 22 and 88 Electronic Control Valves.

MODEL 115-4 THREE-WAY SOLENOID

With Accelorator Operated by a 3-way solenoid which operates a large port accelerator pilot, allowing quick response on larger valves. Standard with needle valve openin